2.5 clutch

[marc61]

Would anyone have a spare or know how to replace the plastic fitting which clips onto the 2.5 clutch pedal and transfers the movement to the master cylinder?

It's the plastic equivalent of a rose joint but less sturdy and mine is worn and drops off when it feels like it - clutch pedal hits the floor etc etc

[xmexclusive]

Replaced the cylinder and pipe assembly in one of mine a few months ago.
Had a recovered complete pedal box on the bench as a guide to what I had to do contorted under the dash.
What came out was not a Citroen cylinder so suspect I used the cylinder and rose on the swap.
Will have a look to see if I can find anything spare over the weekend.

John

[marc61]

Hi John, would you know if the plastic rose unscrews from the rod that transfers movement to the master cylinder, or is it all one piece?

I took the steering wheel assembly out so I could see it a bit better. Managed to keep the rose from pulling itself off by fitting a couple of cable ties to constrain the rod relative to the pedal arm when the pedal is pushed. A bodge, will have to see how long it lasts.

Cheers

Marc