I want to own a S1 now just so I can close the flap on the radio and not see it! Bang a bluetooth headunit in and voila - stealth setup! I like how he didnt even ask his missus/mistriss/mother to move out of the way for the photo's!
Not as cheap as a diesel or as torquey but I reckon on petrol it must do into the 20's on a run so on LPG it will do low 20's but at a lot lower cost depending on how you source the LPG for it
The mileage is reasonably high and the car would need to be imported as it is still registered abroad and has no MOT now.
The seller seems to be a decent chap. I was interested but from the photo's it has bent over front jacking points.
91 3.0 sei M. 4852 EXY Black
92 2.1 sed M. 5740 ECZ Sable Phenicien
92 3.0 V6-24. 5713 EXY Black
92 2.1 sd M. 5685 ENT Blue Sideral
Prev
90 2.1sd M. 5049 EJV Mandarin
92 2.1sd A. 5698 EJV Mandarin
94 2.1sd A. 6218 ERT Triton
91 2.0si M. 5187 EWT White
Actually the PRV V6 on LPG would be as good as a 1.9 XUD...
My V6 SEi is on LPG and old fashioned single point LPG. I would get 44mog equivilent from her! So that WAS DERV economy with V6 blurb too and SEi comforts. (Bear in mind, when I had my V6 on the road the HDi was brand new, so I only had XUD Turbos to compare against..)
Projects:(eventually if theres any bodywork left)
93 L Xm 2.1t D auto project
93 L xm V6 12v Sei Manual
Others
In use.. 1995 M reg S2 2.1td auto exclusive
Could the jacking points not be pulled back out though and depending where it's resided could be less rust prone than the average uk one so would do well after a good rust treatment all round I reckon.
Oh and LPG delivered to a home tank is about 43p/l....
So if a v6 ran on domestic LPG was getting about 21mpg it would be equivalent to a diesel doing 70mpg-ish....
Not bad going really other than losing some boot space to a tank or fitting some underslung ones if there is space under an xm hatch
Bent flat front jacking points usually mean that all the spot welds are pulled apart.
The individual thin sections then rust rapidly initially around each weld burn area.
The bottom of the hidden but key central plate goes missing after a few years.
Given up on a couple of otherwise good XM's when the extent of the rust became obvious.
xmexclusive wrote:
Given up on a couple of otherwise good XM's when the extent of the rust became obvious.
Ditto. It's the first thing I check.
91 3.0 sei M. 4852 EXY Black
92 2.1 sed M. 5740 ECZ Sable Phenicien
92 3.0 V6-24. 5713 EXY Black
92 2.1 sd M. 5685 ENT Blue Sideral
Prev
90 2.1sd M. 5049 EJV Mandarin
92 2.1sd A. 5698 EJV Mandarin
94 2.1sd A. 6218 ERT Triton
91 2.0si M. 5187 EWT White