2.1 drive-shaft joint boot.

[Dieselman]

Does anyone have an inner joint boot for the n/s driveshaft on a 1990 2.1 they can let go, or know where to obtain a quality one and the proper steel clips for reasonable cost, as I have a split boot.

p/n 3287 72 AXLE SIDE (GAITER REF 9564033580)

I found this when checking where the gearbox is leaking...

[robert_e_smart]

Hi Will,

Try Malcolm Lockwood. I bought a few CX ones from him, and they were good quality and came with clips/ligarex.

I have also used el cheapo universal ones with no dire consequences either.

[bobhalliday]

Hi Dieselman,
I've been looking at this one on Ebay 270537588387 The seller has both inner and outer sizes, I don't know what like they are and was going to write to him for more info, especially to know if they have the lip inside to help them stay in place,

Bob.

[Dieselman]

Hi Will,

Try Malcolm Lockwood. I bought a few CX ones from him, and they were good quality and came with clips/ligarex.

I have also used el cheapo universal ones with no dire consequences either.

Any contact details for Malcolm?

[Dieselman]

Hi Dieselman,
I've been looking at this one on Ebay 270537588387 The seller has both inner and outer sizes,
Bob.

Hi Bob.
The ones he has are listed as for 1993 onwards, but I've sent him a message. The brand he has are Bailcast, which are a decent brand.

[robert_e_smart]

Any contact details for Malcolm?

His address is :-
20 Stony lane,
Eccleshill,
Bradford,
BD2 2HN

Tel No 01274 640590/ 079 666 296 33
E-mail malcolmlockwood@btconnect.com

[Dieselman]

Thanks Robert, email sent.