Page 9 of 28

Re: Gasa XM 2.1 "Prestige"

Posted: Sun Mar 26, 2023 9:53 am
by Dieselman
The additional metal shims are anti-squeal shims and should be fitted to reduce the risk of squealing brakes, which is quite likely due to the rear disks being bell shaped.

The original rear disks must have been the correct ones, but the original pads look to be for an estate car, so running over the edge of the disk.

Were the front wishbone rear bushes an interference fit onto the spigot?

Re: Gasa XM 2.1 "Prestige"

Posted: Tue Mar 28, 2023 7:28 am
by Gasa
...everything fits perfectly, they are good silen blocks.

I will see while driving if they have a problem with squealing, probably the plates were for a caravan and the problem was that one plate rested on the other and it didn't brake well.

Re: Gasa XM 2.1 "Prestige"

Posted: Sun Apr 02, 2023 6:57 pm
by Gasa
Today, the left side was closed, and the radiator was also replaced.
IMG_20230331_164559.jpg
IMG_20230331_164609.jpg
IMG_20230331_213142.jpg
IMG_20230331_213215.jpg
...and on this side, only the rear silen block was replaced, the front ones are good.
IMG_20230331_164616.jpg
IMG_20230331_164623.jpg
IMG_20230331_172622.jpg
IMG_20230331_205359.jpg

Re: Gasa XM 2.1 "Prestige"

Posted: Sun Apr 02, 2023 7:03 pm
by Gasa
IMG_20230331_213152.jpg

And finally, the water cooler, intercooler cooler and air conditioner were washed and are completely passable.

IMG_20230402_091056.jpg
IMG_20230402_091524.jpg
..beam cleaned of corrosion and painted.
IMG_20230402_120656.jpg
IMG_20230402_130956.jpg
IMG_20230402_131005.jpg

Re: Gasa XM 2.1 "Prestige"

Posted: Mon Apr 03, 2023 6:32 am
by Dieselman
All coming together, Gasa.
I take it that is a new radiator.

Are the steering rack gaiters leaking?
They can be replaced in situ if you remove the passenger side track rod from the rack.
I would recommend either genuine Citroen ones, or quality thermoplastic ones that have the proper grip to secure them. Avoid cheap, Universal ones, as they only last a couple of years.

Re: Gasa XM 2.1 "Prestige"

Posted: Mon Apr 03, 2023 9:17 pm
by Gasa
Yes, the radiator is new, the cuffs are bad, I have new ones, I need to change the clamps, so I will also replace the cuffs at the same time.
IMG-20230324-162129.jpg
IMG-20230324-162111.jpg

Re: Gasa XM 2.1 "Prestige"

Posted: Tue Apr 11, 2023 5:30 pm
by Gasa
Today's activity was in the form of replacing the O-ring rubbers on the Actuator, the problem was in the form of an oil leak, all the rubbers were replaced, there are 8 of them.
IMG_20230407_190655.jpg
P1190544.JPG
...there was an oil leak problem on this composition.
P1190546.JPG
P1190547.JPG

Re: Gasa XM 2.1 "Prestige"

Posted: Tue Apr 11, 2023 5:38 pm
by Gasa
P1190548.JPG
P1190549.JPG

..care should be taken when removing the pistons, this piston with a spring goes to the engine, care should be taken that it does not fall out during disassembly.
P1190540.JPG
...this piston is without a spring, it is located next to the radiator.
P1190542.JPG
P1190550.JPG
There is nothing complicated to replace, the price for all rubbers is 1 euro :D

Re: Gasa XM 2.1 "Prestige"

Posted: Wed Apr 12, 2023 6:45 am
by Dieselman
Well done Gasa, a known leak area for Delphi-Epic pumps.
Thanks for the write-up, this will be useful for other members to follow.

How much is left to do before this car returns to the road?

Re: Gasa XM 2.1 "Prestige"

Posted: Wed Apr 12, 2023 2:28 pm
by Gasa
There's still a big service left to do, the wheel ties to replace and the cuffs on the steering wheel bar.



I have also completed the search for alloy wheels,I was only looking for original rims, not from Chinese manufacturers :D
P1190515.JPG
P1190516.JPG
P1190517.JPG