Re: Russ's 2.1 SED Auto now in Mandarin
Posted: Mon Nov 02, 2015 2:00 pm
These arrived today. Totally useless.
.....One pip! ERGH!These arrived today. Totally useless.
.....One pip! ERGH!Citroen XM Forum
The global resource for Citroen XM owners
https://club-xm.co.uk/Forum/
Russ's 2.1 SED Auto now in Mandarin
Page 168 of 217
These arrived today. Totally useless.
.....One pip! ERGH!Re: Russ's 2.1 SED Auto now in Mandarin
Posted: Mon Nov 02, 2015 3:46 pm
Pipe has been replaced. An easy job. The one next to the brown plug, with the 90 degree elbow.
My rubbish temporary emergency fix.
And a long overdue pic of the engine in situ. Looks like any other 2.1!
My rubbish temporary emergency fix.
And a long overdue pic of the engine in situ. Looks like any other 2.1!
Re: Russ's 2.1 SED Auto now in Mandarin
Posted: Mon Nov 02, 2015 5:36 pm
Looks like any other 2.1 STRAIGHT OUT OF THE BROCHURE! I wish both of mine looked like that!!
Re: Russ's 2.1 SED Auto now in Mandarin
Posted: Mon Nov 02, 2015 6:05 pm
Wet wipes Ray.... Amazing what they can do to an engine!!! Seriously it's not that good! But thanks.
There is a hilarious amount of air in main the fuel line....
Re: Russ's 2.1 SED Auto now in Mandarin
Posted: Fri Nov 20, 2015 1:47 pm
I think I might have got the reason why the car is slow to rise and throwing up the low pressure message every time it's cold started. Wasn't on for long this morning though... A bit of extra revs helps as well, so the idle could go up a tad.
But today, I noticed the hydraulic pump was noisier than normal. Infact rotating the main pulley wheel when it was off the car, you could hear the internals clacking together... Not badly, but enough for my ignorance to think it was normal.
Rotating the mandarins pump in comparison.. it is silent. So there possibly lies the culprit. Another job to do, swap the pumps.
If it doesn't snow and is not too perishing tomorrow, I might try and change that fuel pipe. And pigs might fly!
But today, I noticed the hydraulic pump was noisier than normal. Infact rotating the main pulley wheel when it was off the car, you could hear the internals clacking together... Not badly, but enough for my ignorance to think it was normal.
Rotating the mandarins pump in comparison.. it is silent. So there possibly lies the culprit. Another job to do, swap the pumps.
If it doesn't snow and is not too perishing tomorrow, I might try and change that fuel pipe. And pigs might fly!
Re: Russ's 2.1 SED Auto now in Mandarin
Posted: Fri Nov 20, 2015 2:40 pm
Fingers (maybe frozen) crossed then.
Re: Russ's 2.1 SED Auto now in Mandarin
Posted: Fri Nov 20, 2015 7:04 pm
Mmmmm possibly.
Re: Russ's 2.1 SED Auto now in Mandarin
Posted: Sat Nov 21, 2015 8:47 am
What type ofcpads are you after russ??
Ive found a couple of those top small water hoses in the shed
Ive found a couple of those top small water hoses in the shed
Re: Russ's 2.1 SED Auto now in Mandarin
Posted: Sat Nov 21, 2015 10:58 am
I'm after new brake pads with the pips. Those ones I pictured had one pip on them so aren't suitable. I might go to AEP, I got my last set from there and they were fine. It's quite hard trying to find pads with the pips.
Water pipes, I had a spare so that's one now. I will be getting another soon too. So thanks, I might have to let you know about that one.
Water pipes, I had a spare so that's one now. I will be getting another soon too. So thanks, I might have to let you know about that one.
Re: Russ's 2.1 SED Auto now in Mandarin
Posted: Sat Nov 21, 2015 4:06 pm
Fuel pipe replaced. So that's all but one that have been completely renewed now. Apart from the nest of other rubber pipes around the fuel tank. Not touching those... Mainly as the tank I think would have to be dropped.
Just hope the new pipe solves the air ingress now. Didn't get to do much else, got too cold. Cor it was a bit brisk today!
So that's all but one that have been completely renewed now. Apart from the nest of other rubber pipes around the fuel tank. Not touching those... Mainly as the tank I think would have to be dropped. Just hope the new pipe solves the air ingress now. Didn't get to do much else, got too cold. Cor it was a bit brisk today!