Citroen XM Forum

Hi Geoff,

The bits I need must be switch blanks that are fitted if the car isn't fitted with heated seats.

Thanks.

Steve.

Steve,

S1 and S2 switches are in different places... The S1 has an ash tray, and a sort of "Aux" power socket next to cigarette lighter... however the whole centre face can be swapped between them..

Paul

Thanks Paul, It sounds as if I'll need to buy the whole panel and swap it over.

Steve.

Bugger - it went with the car this morning (if you mean the whole centre console thing?) If it's the small panel about 6" square then I have that.

The good news for everyone (except Paul who I have pm'd) is that I have all your bits, I just need to pack them up and send them out. I struggled with the rear bumper for Paul and the recovery bloke turned up early, so sadly it's gone with Battlescar - RIP old girl

Got other unclaimed parts which I'll list separately another day.

I'll slowly send you bits out over the next couple of weeks...

I can probably find spare switch blanks (both types) and a S2 rear panel. Si rear panel might take a bit of searching.
Big cardboard box somewhere that I started collecting that type of items in during the last sort through.

John

Hi John,

Thanks for the offer but if Geoff has the 6" I'll try that first rather than deplete your spare stock if that's OK?

Steve.

Steve

No worries.
Just let me know if you fail to source.

John

I do have the '6" rear switch panel' and I lied before as the centre console was deep inside the garage so just shout if you need that as well.

Message for Robert Smart: Do you also need the rubber 'skirt' that fits onto the centre console to go with your leccy arm rest?

The series one alloys with 2000 mile old Dunlop tyres are still up for grabs and I'm open to offers (originally asking £200)
Also the Exclusive Alloys with no tyres at £40 for 4
Matching steel wheel (flat shouldered bolt holes) with a budget tyre with plenty of tread but needs re-seating £10

They need to go!!!!!

Yes please, I need the rubber flap thing.

Who was after the suspension height lever (plastic bit)?

Steelcity, it's item 4 below, the one with the switch apertures, ciggy lighter aperture and ash tray aperture.
Is that the one you want + two blanks? Did you need the rear ash tray as well?