Page 14 of 28

Re: Gasa XM 2.1 "Prestige"

Posted: Tue May 23, 2023 7:38 pm
by Gasa
What does this symbol represent, the temperature of what.
IMG_20230523_213159.jpg

Re: Gasa XM 2.1 "Prestige"

Posted: Wed May 24, 2023 6:44 am
by Dieselman
Water temperature pre-warning lamp.
"If it lights up slow down."

Re: Gasa XM 2.1 "Prestige"

Posted: Wed May 24, 2023 7:07 am
by Gasa
...yes it lit up for a few seconds, I tried it on a short part of the road to see what speed it could reach, it showed 190 km/h and for a moment that notification lit up.

Re: Gasa XM 2.1 "Prestige"

Posted: Wed May 24, 2023 7:26 am
by Dieselman
That's a pretty healthy speed for an atmo diesel., even allowing for spedometer inaccuracy.

Re: Gasa XM 2.1 "Prestige"

Posted: Wed May 24, 2023 8:14 am
by Gasa
Yes, it reached the speed as the factory declares, next time I will use the GPS to check the exact speed.

Re: Gasa XM 2.1 "Prestige"

Posted: Sat Jun 17, 2023 2:43 pm
by Gasa
These days I went to check and refill the air conditioner, for now the weather is bad and there is no need to use it, I still don't know how it cools, if it is strong and meets the needs in high heat. :roll:
IMG_20230615_170733.jpg
IMG_20230615_171323.jpg
IMG_20230615_170741.jpg
IMG_20230615_172510.jpg

Re: Gasa XM 2.1 "Prestige"

Posted: Sat Jun 17, 2023 9:08 pm
by DownUnderXM
Those pressures look perfect - did you have to add much gas?

Re: Gasa XM 2.1 "Prestige"

Posted: Sat Jun 17, 2023 9:50 pm
by Gasa
..yes, there were about 90-100 grams of freon in the system, according to the table, there should be 800 grams in the system.

Re: Gasa XM 2.1 "Prestige"

Posted: Tue Jun 20, 2023 8:29 pm
by Gasa
...what could be the problem that sometimes occurs, that when idling it increases the speed of the engine to 1000-1100 rpm.
from where it receives the command to increase engine speed.

Re: Gasa XM 2.1 "Prestige"

Posted: Wed Jun 21, 2023 6:30 am
by Dieselman
Is that at the point the A/c is switched on?

That actually sounds like the cold start fast idle speed, so check the coolant sensor.

Link to Gabor's Series 2 wiring diagrams.
download/file.php?id=9711