Page 2 of 2
Re: Anyone with a degree in advanced part recognition?
Posted: Sun May 31, 2015 8:04 am
by citronut
the E8 part No. is defiantly MK2 XM in doing an all families search on service citroen as that is all it comes back with, all be it not the part you are after,
regards malcolm
Re: Anyone with a degree in advanced part recognition?
Posted: Sun May 31, 2015 10:07 pm
by David Hallworth
Dieselman wrote:Take yours into a hydraulic hose supplier and have them re-crimp it, or buy one off a scrap car, it can't be a common failure.
It is actually quite a common failure on the V6's. All 3 of them that I've owned have done it and I know of a few others. When I told Robert at BL Auto's I had a leak on a steel to rubber joint on my XM he immediately knew which pipe I was talking about.
He told me that these pipes were badly crimped from the factory and that having them recrimped by a hydraulic specialist is usually a good cure.
David.