Citroen XM Forum

Yes, in this post:

Removing and some work done

Theres some of it there, as for full pictures,





There IS a body dent on that Rear panel above the rear wheel... Its not split the paint at all either.



Minus the alloys, she now has steels with S2 Trims, however, I DO have a set of original Flat Trims that could go on...

And the Strut Tops




Paul

Did you ever get the air con sorted Paul? And what are the orginal flat wheel trims you're referring to?

No I didn't, I never managed to get hold of a Series 2 System. The Air Con compressor is still fitted, as is the Evaporator in the dash... so it just needs the dryer, condenser and assosiated pipe work from an S2 car - I say S2 to be sureits an R134a system..

Im reffering to the "Bowling Ball" trims, fitted to base spec S1 cars!! Someone, got a pic???

Paul

citroenxm wrote:
Im reffering to the "Bowling Ball" trims, fitted to base spec S1 cars!! Someone, got a pic???

Paul

These ones.

http://www.club-xm.co.uk/forum/viewtopi ... =19&t=1244

Thankyou DM Yes those awfull ones!

Paul

citroenxm wrote:Thankyou DM Yes those awfull ones!

Paul

I knew you'd say that...That's why I showed a picture of Roberts car instead of mine..

Thanks Will!

robert_e_smart wrote:Thanks Will!

Actually that was a joke Robert....I only used your photo because your trims are in much better condition than mine.

Here's mine for reference.

http://www.club-xm.co.uk/forum/viewtopi ... =19&t=1609

citroenxm wrote:.....................

I'm referring to the "Bowling Ball" trims, fitted to base spec S1 cars!! Someone, got a pic???

Paul

There's always THIS thread folk's can use for when referring to wheel trims or Alloy wheel's (If you can remember) !



XMX

Should that not be made a Sticky????? Thats rather a usefull posting!!


Paul