1992 2.1 Sd Auto Estate

[Dieselman]

The front bumper outriggers needed some repairs, mainly due to the wheel-arch liner rubber bung being missing.

WP_20251201_008.jpg

WP_20251201_010.jpg

WP_20251203_001.jpg

Cut-out plated and sealed

WP_20251203_002.jpg

WP_20251203_011.jpg

WP_20251203_012.jpg

WP_20251203_009.jpg

I also wire wheeled the wheel-houses and applied seam sealer to areas where it had come away. I also welded the lead edge of the A pillar where the metal layers are only sealed with seam sealer...which breaks down and allows water into the A pillar and front jacking point areas.

The steering gear heat shield clip was missing so I made one from a bit of stainless spring wire. The wire gauge is slightly thinner, so hopefully it will stay in place, if not I'll make one from some thicker metal.

WP_20251203_019.jpg

WP_20251203_020.jpg

Also finally managed to look at the paint code and Rp number

WP_20251201_002 copy.jpg

WP_20251201_001.jpg