Citroen XM Forum

Has anybody got the following for my 96 2.5 td VSX XM. Offside front lower engine mount. Power Steering seals and the reservoir water tank..Thanks Shaun

Where are you located?

I know of a 2.5 being scrapped in E mids.

I am in Sevenoaks Kent...

thanks Dieselman I will give I will give him a ring tomorrow...

Be sure this work is needed.
There is no bottom engine mount on a 2.5TD.
Top and bottom ones are very soft rubber buffer stops.
They allow the engine to rotate back and forth 40 to 50mm either way.
Much more movement than a normal engine.
Exhaust has a flexy section for the extra movement.
There are just two axial engine mounts either end on the centre of gravity of the engine and box.
The top and bottom buffers are routinely replaced without need because the engine suspension method is not understood.

John

THanks xm I wii call my garage on Monday and explain it to them…….That does make sense…..

Water header tanks for 2.5 TD were available new from Citroen a couple of years ago.
If obtaining S/H one then check that the red internals are still good and complete.
These bits control internal water flow direction and also mark fill level.

John

Shaun17 wrote:thanks Dieselman I will give I will give him a ring tomorrow...

Thanks Diesel man I got my parts from Greg Bibby They should arrive Tuesday….thanks again….

Good to hear.

Anyone got a number for Greg Bibby - I need 2.5TD parts.