Series 1 Exhaust Manifold

steelcityuk · Post by **steelcityuk** » Fri Apr 30, 2010 2:56 pm

Hi,

I'm after a Series 1 non EGR exhaust manifold, I would think it's needs to be from a 1992 or older engine.

Thanks.

Steve.

Post by **citroenxm** » Fri Apr 30, 2010 4:38 pm

Phhooooorrrrr thats gonna be a hard find Steve!

I assume for your SED?

Ill keep ears open and let you know if I hear anything.

Paul

Post by **Peter.N.** » Fri Apr 30, 2010 6:50 pm

I think the early 406s used them - there are a lot more of those about.

Peter

Ignore this I read 'inlet'

jonathan_dyane · Post by **jonathan_dyane** » Fri Apr 30, 2010 10:17 pm

You should be able to just remove the EGR valve from the manifold, and make up a little blanking plate to fit in its place.

Post by **citroenxm** » Fri Apr 30, 2010 10:22 pm

That actually, Johnathan, worked well on a Xantia I did..

I swapped a Turbo from a 1997 EGR equpit car to a 1996 non, and made and bolted a blanking plate..

Caused no problems at all!

We also plugged the inlet manifold too... all worked fine!

Paul

steelcityuk · Post by **steelcityuk** » Sat May 01, 2010 7:46 pm

I was intending originally to go along the blanking plate route until I found out earlier cars didn't have EGR but if they are rare then a plate it will be.

Thanks all.

Steve.

Citroen XM Forum

Series 1 Exhaust Manifold

Series 1 Exhaust Manifold

Re: Series 1 Exhaust Manifold

Re: Series 1 Exhaust Manifold

Re: Series 1 Exhaust Manifold

Re: Series 1 Exhaust Manifold

Re: Series 1 Exhaust Manifold